REBOOT(1)               XR32 REFERENCE MANUAL                19/1/2013

COMMAND
        RE[BOOT] -- Reboot machine (Obsolete).

SYNOPSIS
        REBOOT

AVAILABILITY
        This command was implemented on DOS XRouter, but is not
        available in XR32!!!

DESCRIPTION (Obsolete)
        Reboots the machine immediately and ungracefully.

        It is typically used by remote sysops to restart the machine
        after editing autoexec.bat/config.sys, installing a new
        version of the software, or to recover from potentially
        dangerous situations such as a corrupt hard drive.

        Console sysops can use the "Vulcan Nerve Pinch" (Ctrl-alt-del)
        or interrupt the power instead.

NOTE (Obsolete)
        Remote sysops should only use this command if the router
        program has been started from AUTOEXEC.BAT, otherwise it won't
        restart.

        It is recommended that you include an automatic disk check and
        repair utility within AUTOEXEC.BAT to remove any problems
        which resulted in the REBOOT command being used.

SEE ALSO
        RESTART(1) -- Restart XR32

REBOOT(1)                        END OF DOCUMENT